Suspension 32 1 2 3 4 A 320020a 05/27/93 1 A. Lubricate here. 1. Cap-and-Tube Assembly Bushing 4 1 2 09/15/95 f320424 For Hendrickson RT2 and RTE2 Series, lubricate the bronze, ball-indented bushings in the spring eye, as follows: Fig. 8, Equalizer Assembly Lubrication 1. Bronze Bushing 2. Lubrication Hole 3. Grease Fitting 4. Lubrication Groove Fig. 9, Hendrickson RT2 and RTE2 Series Bushing Lubrication 1. Park the vehicle on a level surface, apply the parking brakes, and chock the front tires. 2. Check the U-bolt torque in a diagonal pattern. Set a click-type torque wrench to the highest torque value for the fastener being checked. See Table 1 for U-bolt torque specifications.
Turn the wrench in a clockwise motion (looking up) until the torque wrench clicks. 2. Raise the rear of the vehicle until the rear wheels are suspended in the air, then support the ve- hicle with safety stands. This relieves the load on the bushings and pins to allow the proper flow of lubricant around them. 3. Use a multipurpose chassis grease and lubricate the bronze, ball-indented bushings in the spring eyes at the grease fitting; see Fig. 9 . Continue to lubricate until grease exits both ends of the bushing. If the pin will not accept lubricant, re- move the pin and clean the lubrication channels where lubricant may have hardened. Lower the vehicle and remove the safety stands.
Spring Assembly U-Bolt High Nut Torque Values * Size Torque: lbf·ft (N·m) Stage 1: Hand Tighten Stage 2: 60 (81) Stage 3: 200 (271) Stage 4: 180 to 230 (245 to 313) 5/8–18 Stage 1: Hand Tighten Stage 2: 60 (81) Stage 3: 200 (271) Stage 4: 270 to 330 (367 to 449) 3/4–16 32–03 Suspension U-Bolt Torque Check 7/8–14 Stage 1: Hand Tighten Stage 2: 60 (81) Stage 3: 200 (271) Stage 4: 420 to 500 (571 to 680) NOTICE Failure to retorque the U-bolt nuts could result in spring breakage and abnormal tire wear. 1–14 Stage 1: Hand tighten Stage 2: 60 (81) Stage 3: 200 (271) Stage 4: 520 to 600 (707 to 816) 1. Park the vehicle on a flat surface, apply the park- ing brakes, and chock the tires.
* Tighten in a diagonal pattern as shown in Fig. 10 . Table 1, Spring Assembly U-Bolt High Nut Torque Values 122SD and Coronado 132 Maintenance Manual, February 2016 32/6