Freightliner — 122SD, Coronado 132

Front Axle 33 33–00 Safety Precautions Safety Precautions in this section apply to all procedures within this group. 1 DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. A 33–01 Knuckle Pin Lubrication, Detroit and Dana Spicer® Axles NOTICE Use regulated pressure when lubricating the knuckle assemblies, otherwise damage could re- sult to the knuckle caps. Detroit Axles B 1 06/07/2012 f330272 A Upper View, LH Side B Lower View, LH Side 1.

Grease Fitting 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. When lubricating upper and lower knuckle assemblies, do not raise the front axle. Fig. 1, Grease Fittings, Detroit Axles 2. Wipe the fittings clean. 3. Apply multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), until new grease is seen at the junctions of the axle beam and knuckles. For locations of grease fittings, see Fig. 1 ; for grease exit points, see Fig. 2 . Dana Spicer 09/13/2012 f330275 Park the vehicle on a level surface, apply the parking brakes, and chock the tires.

When lubricating upper and lower knuckle assemblies, do not raise the front axle. Wipe the fittings clean, then apply multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12- hydroxy lithium stearate grease), until new grease is Fig. 2, Knuckle Pin Grease Exit Points, Detroit Axles seen at the junctions of the axle beam and knuckles. See Fig. 3 . Knuckle pins without grease fittings are permanently lubricated. 122SD and Coronado 132 Maintenance Manual, February 2016 33/1