Freightliner — 122SD, Coronado 132

Front Axle 33 1 1 A 11/21/95 f330129 A. Grease Exit 1. Grease Fitting 09/06/96 f320032a 1 33–02 Knuckle Pin Lubrication, Meritor® Axles Fig. 3, Dana Spicer Knuckle Pin Lubrication A. Grease Exit 1. Grease Fitting Fig. 4, Meritor Knuckle Pin Lubrication 2. Check for a missing cotter pin or loose tie-rod end nut. Tighten as needed. Install a cotter pin if it is missing. NOTICE Use regulated pressure when lubricating the knuckle assemblies, otherwise damage could re- sult to the knuckle caps. 3. Shake the cross-tube. A loose fit, or movement between the tapered shaft of the ball and the cross-tube socket members indicates that the tie-rod end assembly must be replaced.

Park the vehicle on a level surface, apply the parking brakes, and chock the tires. When lubricating knuckle pin bushings, do not raise the front axle. Wipe the lube fittings clean, and apply multipurpose chassis grease, NLGI Grade 2 (8% 12-hydroxy lithium stear- ate grease), until new grease is seen at the bushing grease seal opposite the fittings. The grease seal will accept grease pressure without damage, and is de- signed to have grease pumped out through it during lubrication. Even if grease leaks out around the top, or bottom-plate gasket, continue pumping until new grease is seen at the bushing seal opposite the grease fitting; see Fig. 4 . 4.

The threaded portion of the tie-rod end assembly must be inserted all the way into the cross-tube split for adequate clamping; see Fig. 5 . Replace the components if this cannot be done; see Group 33 of the 122SD and Coronado Work- shop Manual . 33–04 Tie Rod Lubrication, Detroit and Dana Spicer Axles NOTE: For operation in very cold climates, use NLGI Grade 1 (6% 12-hydroxy lithium stearate grease).

Detroit Axles For any Detroit axle that requires lubrication of the tie-rod ends, wipe the grease fittings clean, then pump multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), into the tie-rod ends until all used grease is forced out and fresh grease is seen at the ball stud neck. See Fig. 6 . 33–03 Tie Rod Inspection 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 122SD and Coronado 132 Maintenance Manual, February 2016 33/2 A 1