Freightliner — 122SD, Coronado 132

Front Axle 33 rod ends until all used grease is forced out and fresh grease is seen at the ball stud neck. OK NOTE: For operation in very cold climates, use NLGI Grade 1 (6% 12-hydroxy lithium stearate grease). 33–05 Tie Rod Lubrication, Meritor Axles 1 For any Meritor axle that requires lubrication of the tie-rod ends, wipe the grease fittings clean, then pump multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), into the tie-rod ends until all used grease is forced out and fresh grease is seen at the ball stud neck. OK 02/27/2007 f320033a 33–06 All-Axle Alignment Check NOTE:

Shown without pinch bolt to provide clarity. 1. Cross-Tube Split Fig. 5, Tie-Rod End Adjustment Drive Axle Alignment Checking Check the axle alignment, parallelism, and thrust angle measurements for the rear drive axles. Use the applicable procedure and specifications in Group 35 of the vehicle Workshop Manual. Toe-In Inspection 2 For vehicle alignment to be accurate, the shop floor must be level in every direction. The turn plates for the front wheels must rotate freely without friction, and the alignment equipment must be calibrated every three months by a qualified technician from the equipment manufacturer. Freightliner dealers must have proof of this calibration history.

06/12/2012 f330273 1 NOTE: No grease should emit from the tie-rod boot. If grease emits from the tie-rod boot, the boot is dam- aged. 1. Apply the parking brakes and chock the rear tires. 1. Grease Fitting 2. Boot 2. Raise the front of the vehicle until the tires clear the ground. Place safety stands under the axle. Fig. 6, Grease Fitting and Boot, Detroit Axle Dana Spicer 3. Using spray paint or a piece of chalk, mark the entire center rib of each front tire. For any Dana Spicer axle that requires lubrication of the tie-rod ends, wipe the grease fittings clean, then pump multipurpose chassis grease, NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), into the tie- 4.

Place a scribe or pointed instrument against the marked center rib of each tire, and turn the tires. The scribe must be held firmly in place so that a single straight line is scribed all the way around each front tire. 122SD and Coronado 132 Maintenance Manual, February 2016 33/3