Front Axle 33 5. Place a turn-plate or turntable under both front tires. Remove the safety stands and lower the vehicle. Remove the lock-pins from the gauges; make sure the tires are exactly straight ahead. NOTE: If turn-plates or turntables are not avail- able, lower the vehicle. Remove the chocks from the rear tires and release the parking brakes. Move the vehicle backward, then for- ward about six feet (two meters). 6. Place a trammel bar at the rear of the front tires; locate the trammel pointers at spindle height, and adjust the pointers to line up with the scribe lines on the center ribs of the front tires. See Fig. 7 . Lock in place. Check that the scale is set on zero.
f330014a 08/30/94 Fig. 8, Trammel Bar Positioning f330082a 08/29/94 NOTE: B minus A equals toe-in. Fig. 7, Wheel Toe-In (overhead view) 7. Place the trammel bar at the front of the tires (see Fig. 8 ) and adjust the scale end so that the pointers line up with the scribe lines. See Fig. 9 . f400100a 08/30/94 8. Read the toe-in from the scale, and compare it to the toe-in specification in Group 33 of the ve- hicle Workshop Manual. If corrections are needed, refer to Group 33 of the vehicle Work- shop Manual for instructions on adjusting the toe-in. Fig. 9, Setting Trammel Bar Pointers 122SD and Coronado 132 Maintenance Manual, February 2016 33/4 A B