Rear Axle 35 35–00 Safety Precautions 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. Safety Precautions in this section apply to all procedures within this group. 2. Clean the fill plug and the area around it. In the axle housing rear cover, remove the plug from the oil fill hole. See Fig. 1 . DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death.
35–01 Axle Lubricant and Filter Change, and Magnetic Strainer Cleaning (Synthetic Lubricant) 2 A NOTICE 1 When operating under adverse conditions, it may be necessary to change the axle lubricant at more frequent intervals than listed in the scheduled maintenance tables. Failure to do so could result in axle damage. IMPORTANT: For all axles, including tandem- drive axles and two-speed axles, do the proce- dures under the heading, "All Axle Models." For a two-speed axle with a shift unit, also change the shift unit lubricant. See under the heading, "Two-Speed Axles With Shift Unit." 2 All Axle Models Detroit 4 3 IMPORTANT:
On Detroit axles, the oil change interval for long haul vehicles can be extended to 500,000 miles (800 000 km) for axles with weight ratings of 34,000 to 40,000 lb (15 000 to 18 000 kg) using synthetic lubricant if a lubricant analysis shows adequate quality. Oil must be changed at least every four years, and more often if the axle is exposed to high temperatures and steep grades. B 12/07/2010 f350509a A. Front View B. Rear View 1. Axle Breather 2. Breather Hose 3. Temperature Sensor Port 4. Oil Fill Plug Fig. 1, Detroit Tandem Axle (forward axle shown) 122SD and Coronado 132 Maintenance Manual, February 2016 35/1