Freightliner — 122SD, Coronado 132

Rear Axle 35 NOTE: Some Detroit axles have a small tapped and plugged hole near and below the housing oil fill hole. This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. Be careful when draining the axle oil. It may be very hot, and could cause personal injury if it con- tacts the skin. 3. Place a drain pan under the rear axle drain plug. Drain the oil when it is warm. At this tempera- ture, the oil will run more freely and ensure that the axle is flushed. 5.1 Fill the axle through the oil fill hole. Lubri- cant should be level with the bottom of the oil fill hole. To check fluid level, see Fig. 2 . 4. Clean the fill and drain plugs.

Change them if necessary. 5.2 Install and tighten the fill plug 30 lbf·ft (41 N·m). 4.1 For magnetic plugs, use a piece of key stock or any other convenient steel slug to short the two magnetic poles and divert the magnetic field. Detroit Rear Axle Lubricant Capacity Axle Oil Capacity: Quarts (liters) Forward-Rear 15.9 (15.0) * 4.2 Clean away the collected material depos- ited on each pole. Magnets will rapidly lose their effectiveness as collected mate- rial bridges the gap between the two poles. Single and Rearmost Tandem 10.6 (10.0) * * Actual oil capacity might vary slightly depending on gear ratio.

Table 2, Detroit Rear Axle Lubricant Capacity 4.3 After the first oil is changed, inspect the drain plug each time for large quantities of metal particles. 4.4 After cleaning, install the drain plug(s) and tighten to 30 lbf·ft (41 N·m). A 5. Fill the axle with the recommended lubricant. See Table 1 for recommended drive axle lubri- cants and Table 2 for lubricant capacities. B Detroit Drive Axle Lubricants * IMPORTANT: Lubricant used in Detroit rear axles must meet Mercedes-Benz specification 235.20 (mineral) or 235.8 (synthetic). Mobil Delvac Gear Oil A 80W-90 and Mobilube HD-A Plus 80W-90 meet specification 235.20.

Mobil Delvac 1 Gear Oil 75W-90 and Mobilube 1 SHC 75W-90 meet specification 235.8. For more product information, see http://bevo.mercedes-benz.com. 08/17/2009 f350061a A. Correct (lube level at bottom of fill hole) B. Incorrect (lube level below fill hole) Fig. 2, Axle Lubricant Level Inspection Meritor® Type Ambient Temperature SAE Viscosity Grade IMPORTANT: If using synthetic lubricant in an axle equipped with a pump and filter system, the lubricant change interval is extended to 500,000 miles (800 000 km). Synthetic Oil (–40°C) and up 75W–90 Mineral Oil (–26.1°C) and up 80W–90 * Detroit rear axles do not require the use of friction modifiers.

There is no upper limit on the ambient temperature, but axle sump tem- perature must never exceed 250°F (121°C). Table 1, Detroit Drive Axle Lubricants IMPORTANT: Meritor rear axles do not require the use of friction modifiers. 1. Park the vehicle on level ground, apply the park- ing brakes, and chock the front tires. 122SD and Coronado 132 Maintenance Manual, February 2016 35/2 CAUTION