Rear Axle 35 2. Remove the axle carrier fill plug. Then remove the drain plug from the bottom of the housing. Completely drain the lubricant while the unit is warm, to allow the lubricant to drain faster. 5. Clean the fill and drain plugs as follows. Change them if necessary. On tandem-drive axles, it is also necessary to remove the plug at the bottom of the interaxle differential housing to drain that lubricant. 3. If equipped with an oil pump, remove the axle oil filter. Use a suitable filter strap wrench; see Fig. 3 . Discard the old filter. NOTE: There may be about one pint (0.5 L) of lubricant remaining in the filter. Be careful not to spill it when removing the filter. 4.
Using the recommended drive axle lubricant, coat the face of the gasket on the new oil filter, if one was removed. Install the filter over the adapter, and tighten the filter one full turn after the gasket contacts the base; do not overtighten. See Table 3 for recommended lubricants. f350119a 05/27/93 Fig. 3, Meritor Axle Oil Filter Removal Meritor Drive Axle Recommended Lubricant Recommended Lubricant Type Ambient Temperature Lubricant SAE Viscosity Grade Meritor Specification Synthetic Gear Oil (–40°C) and Up * 75W–90 (–40°C) and Up * 75W–140 * There is no upper limit on these outside temperatures, but axle sump temperature must never exceed 250°F (121°C).
Table 3, Meritor Drive Axle Recommended Lubricant 5.1 For magnetic plugs, use a piece of key stock or any other convenient steel slug to short the two magnetic poles and divert the magnetic field. 6. Fill the axle with recommended lubricant as fol- lows. See Table 4 for drive axle lubricant capaci- ties. 5.2 Check the drain plug for metal particles every 100,000 miles (160 000 km). Clean away the collected material deposited on each pole. Magnets will rapidly lose their effectiveness as collected material bridges the gap between the two poles. NOTE: Some Meritor axles have a small tapped and plugged hole near and below the housing lubricant fill hole.
This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. 5.3 Each time the oil is changed, replace any magnetic drain plug that does not meet the minimum pickup capacity. 6.1 With the vehicle on a level surface, fill the axle through the oil fill hole. Allow a few minutes for the oil to flow into the axle. Lubricant should be level with the bottom of the oil fill hole. To check fluid level, see Fig. 2 . NOTE: Meritor recommends plugs with ele- ments having a minimum pickup capacity of 1.5 pounds (0.7 kg) of low-carbon steel. 6.2 Install and tighten the fill plug 35 lbf·ft (47 N·m).
5.4 After cleaning, install the drain plug(s) and tighten to 35 lbf·ft (47 N·m). 122SD and Coronado 132 Maintenance Manual, February 2016 35/3