Freightliner — 122SD, Coronado 132

Rear Axle 35 7. Whenever the interaxle differential housing has been drained, add an additional 2 pints (0.9 L) of the recommended lubricant directly into the inter- axle differential housing. Meritor Drive Axle Lubricant Capacities Axle Model Capacity * : pt (L) 8. Remove the chocks, then drive the vehicle, un- loaded, for 1 or 2 miles (2 or 3 km) at speeds not to exceed 25 mph (40 km/h), to thoroughly circulate lubricant throughout the carrier and housing assemblies. RT–70–380 Forward 54.4 (25.7) Rear 53.1 (25.1) * Quantities listed are approximate. Fill axle until lubricant is level with bot- tom of fill hole with vehicle on level ground.

Table 4, Meritor Drive Axle Lubricant Capacities Meritor Drive Axle Lubricant Capacities Dana® Spicer® Axle Model Capacity * : pt (L) Single-Drive, Single Reduction IMPORTANT: The use of friction modifiers is not approved in Dana drive axles. RS–21–160 39.5 (18.7) 1. Park the vehicle on level ground, set the parking brakes, and chock the tires. RS–23–160 39.5 (18.7) RS–23–161 37.2 (17.6) RS–23–185 47.3 (22.4) 2. Clean the fill plug and the area around it. In the axle housing rear cover, remove the plug from the oil fill hole (or standpipe, if installed in the oil fill hole); see Fig. 4 .

RS–23-186 47.3 (22.4) RS–26-185 46.0 (22.0) MT–40–143MA–N Forward 30.2 (14.3) Tandem-Drive, Single Reduction 1 Rear 25.8 (12.2) RT–40–145, RT–40–145A, RT–40–145P Forward 30.2 (14.3) RT–40–160 Forward 39.1 (18.5) Rear 25.8 (12.2) Rear 39.4 (16.3) RT–44–145, RT–44–145P Forward 29.3 (13.9) 2 RT–46–160, RT–46–160P Forward 39.1 (18.5) Rear 25.1 (11.9) Rear 34.4 (16.3) RT–46–164EH/P Forward 38.0 (18.0) f350018a 05/27/93 RT–50–160 Forward 38.0 (18.0) Rear 33.0 (15.0) 1. Oil Fill Plug 2. Oil Drain Plug Rear 33.0 (15.0) Fig. 4, Dana Spicer Axle Housing Drain and Fill Plugs RT–52–185 Forward 56.1 (26.5) 3. Place a drain pan under the rear axle drain plug; see Fig. 4 .

Drain the oil at normal operating tem- perature, 150°F to 200°F (65°C to 93°C). At this temperature, the oil will run more freely and en- sure that the axle is flushed. NOTE: Some tandem-drive axles are equipped with a cylindrical magnetic strainer, located below the lube pump on the front of the power RT–58–185 Forward 56.1 (26.5) Rear 36.1 (17.1) Rear 36.1 (17.1) 122SD and Coronado 132 Maintenance Manual, February 2016 35/4