Freightliner — 122SD, Coronado 132

Driveline 41 41–00 Safety Precautions Bearing Cap or Bearing Strap Capscrew Torque Specifications Safety Precautions in this section apply to all procedures within this group. U-Joint Type Torque: lbf·ft (N·m) Half-Round Yokes with Bearing Straps and 3/8-inch Capscrews (see Fig. 2 , Ref. 8) 45–60 (60–80) DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. Half-Round Yokes with Bearing Straps and 1/2-inch Capscrews ( Fig. 2 , Ref.

8) 130–135 (175–185) Full-Round Yokes with Bearing Cups ( Fig. 3 ) 43 (58) RPL Series U-Joints with Bearing Cups ( Fig. 4 ) 125 (169) 41–01 Driveline Inspection Table 1, Bearing Cap or Bearing Strap Capscrew Torque Specifications 1. Park the vehicle on a flat, level surface, apply the parking brakes, and chock the tires. WARNING Self-locking bearing-cup or bearing-strap cap- screws must not be reused; replace the cap- screws with new ones. Also, do not undertighten or overtighten any bearing-cup or bearing-strap capscrews.

A loose or broken fastener at any point in the driveline weakens the driveline con- nection, which could cause serious vehicle dam- age, or could result in a driveshaft separating from the vehicle, possibly causing loss of vehicle control that could result in serious personal injury or death. 2 1 1 2 12/16/2008 f410529 Tighten the capscrews in a counterclockwise sequence, starting with either number 1 position. 2. Check the torque of the bearing-cup or bearing- strap capscrews; see Table 1 for installed torque values. Fig. 1, Tightening Sequence, Half-Round Yoke Bearing Strap Capscrews Remove and discard any loose capscrews.

Do not reuse any loosened self-locking capscrews; they are designed for one-time installation only. Replace all loosened and removed capscrews with new ones. Tighten the new capscrews as specified in Table 1 . 3. Check the driveline yokes for cracks, and check end-yokes for looseness; see Fig. 2 . Replace cracked yokes. If any end-yoke can be moved in or out on its shaft, or can be rocked on its shaft, disconnect the driveshaft and U-joint from the yoke, then check the drive component’s shaft seal for leak- age or other visible damage that may have been caused by the loose yoke. Replace the seal if needed, then tighten the yoke nut.

Refer to Sec- tion 41.00, Specifications 400 of the 122SD and Coronado Workshop Manual for torque specifica- For half-round yokes with bearing straps , tighten the bearing-strap capscrews following the tight- ening sequence shown in Fig. 1 , in increments of 20 lbf·ft (25 N·m) to the torque specifications listed in Table 1 . 122SD and Coronado 132 Maintenance Manual, February 2016 41/1