Driveline 41 14 15 13 7 8 9 3 16 12 11 1 2 4 5 6 10 05/01/95 3 f410067b NOTE: Not all fasteners are shown. 1. Transmission 2. Transmission Output-Shaft End-Yoke (half-round) 3. U-Joint Assembly 4. Bearing Plate Self-Locking Capscrew 5. Bearing Cup (for full-round yoke) 6. U-Joint Cross 7. Bearing Cup (for half-round yoke) 8. Bearing Strap and Bearing- Strap Capscrew 9. Slip-Joint Assembly 10. Sleeve-Yoke (full-round) 11. Dust Cap 12. Splined Stub Shaft 13. Driveshaft Tube 14. Tube-Yoke (full-round) 15. Axle Input-Shaft End-Yoke (half-round) 16. Rear Axle Fig. 2, Components of a Basic Driveline tions. If the yoke is still loose after tightening the yoke nut, replace the end-yoke and yoke nut.
5. Check if the midship bearing and mounting are loose or have deteriorated, by attempting to move the driveshaft up and down, and from side to side. If the bearing is loose on its shaft, or rattles, replace it. If the bearing mount is loose on the frame, tighten the mounting fasteners to the proper torque value. See Section 41.00, Specifications 400 of the 122SD and Coronado Workshop Manual for torque specifications. Re- place the midship bearing assembly if the rubber cushion is deteriorated or oil-soaked. Replace the prevailing torque locknut (end-yoke nut) if it was removed for yoke replacement, seal replacement, or any other reason. 4.
Check U-joint assemblies for wear by moving the driveshaft up and down, and from side to side. If any movement of the U-joint cross in the bear- ings can be felt or seen, replace the U-joint as- sembly. 122SD and Coronado 132 Maintenance Manual, February 2016 41/2