Freightliner — 122SD, Coronado 132

Driveline 41 1 2 M E R I T O R f410012a 05/27/93 Attempt to move the sleeve-yoke and splined shaft back and forth. 1 1 Fig. 5, Slip Joint Spline Wear Checking f410155a 04/13/98 8. Examine the driveshaft for evidence of missing balance weights, and for build-up of foreign ma- terial. Remove any foreign material. If there is any evidence that balance weights are missing, remove the driveshaft and have it balanced. 1. Self-Locking Capscrew 2. Adhesive Band Fig. 3, Meritor U-Joint Fasteners for Full-Round Yokes 9. For driveshafts with slip joints, check to be sure the yoke plug is not loose or missing; see Fig. 6 , Ref. 2. Repair or replace the yoke plug as needed.

If the yoke plug is missing, the splined shaft may be hitting the plug and knocking it out; contact your Regional Service Office for assis- tance in determining the correct driveshaft length. 41–02 Driveline Lubrication Universal Joint Lubrication f410182 12/09/97 NOTE: Vehicles equipped with Meritor RPL Se- ries drivelines do not require periodic lubrication. Fig. 4, Meritor RPL Series U-Joint 6. Check slip joints for spline wear by moving the sleeve-yoke and splined shaft back and forth; see Fig. 5 . If the slip joint can be twisted in a clockwise, or counterclockwise movement greater than 0.007 inch (0.18 mm), replace both the sleeve-yoke and the splined shaft. 1.

Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 2. Wipe all old grease and dirt from each U-joint grease fitting. See Fig. 6 . 3. Use a hand-type grease gun, or a high-pressure gun with a low-pressure adapter, to lubricate U-joints. If a low-pressure adapter is not used, U-joints may not receive enough grease. 7. Examine the driveshaft tubes for dents, bends, twists, or other damage. If any tube appears to be damaged, refer to Section 41.00 of the 122SD and Coronado Workshop Manual for re- pair and replacement instructions.

Using lithium 12-Hydroxy stearate grease (NLGI Grade 2, with EP additives), lubricate until new grease can be seen at all four U-joint seals. Fresh grease must be seen escaping from all 122SD and Coronado 132 Maintenance Manual, February 2016 41/3