Driveline 41 5 screws at the bearing with the dry seal, to relieve seal tension. Lubricate the U-joint until new grease is seen at the seal, then tighten the cap- screws to the correct torque specifications. If the bearing will not take grease, replace the U-joint. Refer to Group 41 of the vehicle Workshop Manual for replacement instructions. 1 3 4 6. Check the purged grease. If it appears rusty, gritty, or burned, replace the U-joint. 2 3 7 7. Wipe the purged grease from the seals, and any excess grease from the grease fitting. 6 Slip Joint Spline Lubrication NOTE: Vehicles equipped with Meritor RPL Se- ries drivelines do not require periodic lubrication. 3 1 8 1.
If equipped with a grease fitting, wipe all old grease and dirt from the slip joint grease fitting. See Fig. 6 . A 2. Use a hand-type grease gun or a high-pressure gun with a low-pressure adapter, to lubricate the slip joint. Add multipurpose chassis grease (lithium 12-hydroxy stearate, NLGI Grade 2, with EP additives) until it appears at the pressure- relief hole in the yoke plug. Then cover the relief hole with your finger, while continuing to apply gun pressure until new grease appears at the slip joint seal. See Fig. 6 . This ensures complete lubrication of the splines. f410050a 10/20/93 A. After grease appears, cover the pressure-relief hole while continuing to lubricate. 1.
Slip Joint Grease Fitting (with grease gun attached) 2. Yoke Plug 3. Grease 4. Half-Round Yoke 5. Yoke Plug Pressure-Relief Hole 6. Slip Joint Seal 7. Full-Round Yoke 8. U-Joint Grease Fitting 3. Wipe the purged grease from the pressure-relief hole and slip joint seal, and any excess grease from the grease fitting. Fig. 6, Slip Joint and U-Joint Lubrication four bearing-cap seals of each U-joint. On full- round yokes equipped with a bearing cup, if most of the grease being added to a U-joint can be seen escaping from just one of the U-joint seals, check the torque on the capscrews at that seal. 4. Tighten the bearing-cup capscrews 43 lbf·ft (58 N·m).
If the capscrews were already tight, or all of the U-joint seals still do not purge, remove the bearing cup at that seal, and examine the seal for damage. If the seal is damaged, replace the complete U-joint. 5. If grease does not appear at one seal, use a pry- ing tool to pry the U-joint trunnion away from the non-purging seal, or tap the driveshaft or yoke with a plastic or rawhide mallet on the side oppo- site the dry seal, while continuing to lubricate. If grease still does not appear, loosen the cap- 122SD and Coronado 132 Maintenance Manual, February 2016 41/4