Brakes 42 42–00 Safety Precautions NOTE: The compressor discharge line may still contain residual air pressure, open the line slowly. Safety Precautions in this section apply to all procedures within this group. 3. Identify, tag, and disconnect the three air lines from the end cover. DANGER 4. Disconnect the harness connector from the heater and thermostat assembly. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 5.
Loosen the bolt that secures the upper mounting bracket strap. 6. Remove the two bolts and Nylok® nuts that se- cure the air dryer to the lower mounting bracket. Mark the position of the mounting bracket to the end cover and mark the bolts to ease installation. 42–01 Air Brake System Valve Inspection 7. Remove the upper mounting bracket strap fas- teners, then remove the strap and the air dryer. 8. Place the air dryer on a bench and remove the remaining 6 bolts, 12 washers, 6 Nylok nuts, and the air dryer housing. See Fig. 1 . Discard the Nylok nuts. Remove the end-cover-to-housing O-ring. NOTE:
There is no scheduled air valve mainte- nance on vehicles equipped with Bendix air valves and a Bendix air dryer if the air dryer desiccant is replaced at 350,000 miles (563 000 km). If the desiccant is not changed at 350,000 miles (563 000 km), or if the vehicle is equipped with another air dryer, maintenance will have to be performed to the air brake valves. See Group 42 of the vehicle Workshop Manual for procedures. 9. Clamp the desiccant cartridge in a vise. WARNING Clamping the end cover or housing in a vise could seriously compromise the air dryer’s ability to hold air pressure, which could cause a failure in the brake system, resulting in property damage, personal injury, or death.
IMPORTANT: For vehicles equipped with an oil- coalescing air dryer desiccant cartridge, replace the cartridge once a year, regardless of mileage. 10. Twist the end cover counterclockwise to release the cartridge from the end cover. Rotate the end cover until it completely separates from the des- iccant cartridge. NOTE: A substantial torque, up to 50 lbf·ft (68 N·m), may be necessary to remove the desic- cant cartridge. 42–02 Bendix Air Dryer Desiccant Replacement IMPORTANT: For vehicles equipped with an oil- coalescing air dryer desiccant cartridge, replace the cartridge once a year, regardless of mileage.
NOTICE AD–9 Dirt or obstructions in the O-ring grooves can cause an O-ring failure that will result in an air leak. 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 2. Completely drain all air reservoirs. Air pressure gauges should read 0 psi (0 kPa). 11. Inspect the condition of the O-ring seals. If they are cracked, crimped, or otherwise damaged, replace them to ensure an airtight seal. Clean the O-ring grooves of any dirt or obstruction. 122SD and Coronado 132 Maintenance Manual, February 2016 42/1