Freightliner — 122SD, Coronado 132

Brakes 42 Group 42 of the vehicle Workshop Manual for mounting instructions. 9. Remove the heater/thermostat assembly and place it in a freezer for about five minutes to cool it below 40°F (5°C). Remove the cold heater/thermostat assembly and check resis- tance between the heater/thermostat terminals. Resistance should be 1.5 to 3.0 ohms. As the temperature of the heater/thermostat assembly increases, the ohm reading will increase. When the temperature goes above 45°F (7°C) mea- sured resistance should be infinite ohms. If the heater/thermostat does not operate as outlined, replace it. If it does operate as outlined, install it. 4. Turn on the ignition switch, but do not start the engine. 5.

Disconnect the harness connector from the air dryer. 6. Connect a voltmeter to circuit 94 on the air dry- er’s harness connector and to a body ground point. Check for battery voltage. If voltage is not found, check and repair the open or short to ground in wire 94. 7. Connect a voltmeter between the two terminals on the air dryer’s harness connector. If voltage is not found, repair the open in the ground circuit wiring. 42–04 Alcohol Evaporator Cleaning and Inspection 8. Use an ohmmeter to check resistance between the terminals on the end cover. See Fig. 4 . The end cover contains the heater/thermostat.

If the heater/thermostat is between 40 and 90°F (5 and 32°C), the heater/thermostat measured resis- tance will be infinite ohms. If the measured resis- tance is less than infinity, replace the heater/thermostat. Maintenance is required during both the freeze sea- son and the off season to keep the alcohol evapora- tor in good working order. Off Season During the off season, drain the unit of alcohol. At regular engine service intervals, open the drain cock to remove moisture from the alcohol evaporator. Be- fore reactivating the evaporator for the next freeze season, drain, disassemble, inspect, and steam- clean the unit of any sludge that may have accumu- lated.

It is advisable to replace any rubber parts when assembling the alcohol evaporator. Perform this service just before the freeze season. Freeze Season Reactivation 1. Park the vehicle on a level surface and apply the parking brakes. Shut down the engine. Chock the tires. 2. Remove the filler cap, and check the cap tet- raseal. 3. Remove the capscrews and reservoir from the cover. 1 4. Remove the cover tetraseal. 5. Drain the air tank, and disconnect the line from the evaporator outlet. Remove the check-valve retainer, spring, and disc. 06/04/96 f421384 2 6. Install the disc, spring, and check-valve retainer, and connect the line to the evaporator outlet. 1. End Cover Assembly 2.

Heater/Thermostat Terminals Fig. 4, End Cover Terminals Location 7. Install the cover tetraseal. 122SD and Coronado 132 Maintenance Manual, February 2016 42/5