Freightliner — 122SD, Coronado 132

Brakes 42 8. Install the reservoir on the cover and tighten the capscrews. WARNING 9. Fill the reservoir with 40 ounces (1183 mL) of methyl alcohol, then install the filler cap. Manually adjusting an automatic slack adjuster to bring the pushrod stroke within legal limits is likely masking a mechanical problem. Adjustment is not repairing. Before adjusting an automatic slack adjuster, troubleshoot the foundation brake system and inspect it for worn or damaged com- ponents. Improperly maintaining the vehicle brak- ing system may lead to brake failure, resulting in property damage, personal injury, or death. 42–05 Brake Inspection Parking Brake Operational Check IMPORTANT:

This procedure should be per- formed prior to lubrication of the brake compo- nents. 2. With the engine off, and 100 psi (689 kPa) of air tank pressure, have an assistant apply and hold an 80 to 90 psi (550 to 620 kPa) brake applica- tion. Perform the following check in a clear safe area. If the parking brakes fail to hold the vehicle, per- sonal injury or property damage may result. 3. Check to see if the colored over-stroke band on each brake chamber pushrod is exposed. If a band shows, the stroke is too long. Check the foundation brake components for wear or damage, and repair as needed. See Group 42 of the vehicle Workshop Manual for inspection and repair procedures. 1.

With the engine running, and air pressure at cut- out pressure, set the parking brake. 2. Put the vehicle in the lowest gear and gently at- tempt to move it forward. The vehicle should not move. If the vehicle moves, the parking brakes are not operating correctly and must be repaired before the vehicle is returned to service. See Group 42 of the vehicle Workshop Manual for repair procedures. Brake Component Inspection 4. Measure the applied chamber stroke. See Table 1 for the proper stroke for the type of chamber being used. If the stroke is too short, the brakes may drag or will not fully apply. Check for improper operation or adjustment of the auto- matic slack adjuster.

See Group 42 of the ve- hicle Workshop Manual. 1. Park the vehicle on a level surface, set the park- ing brake, and chock the tires. Once the tires are chocked, release the parking brake. 122SD and Coronado 132 Maintenance Manual, February 2016 42/6 CAUTION