OPERATION OPERATION INSPECTION AND REPAIR Frequent inspection and prompt repair will reduce repair costs. The following items for inspection will serve as a guide to maintenance service of each undercarriage part. Per- form periodical inspection and contact the Komatsu distributor in your area when machine has approached repair- able limits and reversing limits. MEASURING LINK PITCH 1. Insert a wooden block between track shoe and sprocket to take up the slack in track shoes. 2. Measure pitch length of 4 links in stretched portion at more than 2 links away from master pin. Of length obtained, 1/4 is the link pitch. G Basic link pitch (P): 190mm (7.5in) G Link pitch limit for turning:
193mm (7.6in) There is no link window on the master link. REMARK The measured value after the decimal point for the link pitch may be different from basic link pitch (P), even if there is no wear. This depends on the tolerance for the machining dimensions and the precision of measurement. Do not immediately judge that there is wear; take measurements periodically and judge from the trend. MEASURING HEIGHT OF GROUSER (D61EX) After taking up slack in track shoes, measure height at center of shoe as shown below. G Standard height (h): 55.5mm (2.2in) G Repair limits: 16.5mm (0.7in) 3-86