Komatsu — CLEAN, CHECK REDIATOR FINS

MAINTENANCE SERVICE PROCEDURE REMARK G If the cutting edge and the end bit on both sides are worn out, replace with new one. G If it has been worn out up to the fitting surface, repair the fitting surface and then reverse or replace. 4. Remove the cutting edge and the end bit and clean the mounting surface. 5. Reverse or replace the cutting edge and the end bit when worn out. 1) Remove nut(1) and bolt(2), then replace or reverse the cutting edge and the end bit. 2) Install the cutting edge to the blade and tighten the bolt temporarily. Press the blade against the ground to eliminate the play of bolt(2), then tighten the bolt to the specified torque. Nut tightening torque:

Power angle, powertilt dozer (EX,PX): 461 ± 69N•m (47 ± 7kgf•m, 340 ± 51lbft) Powertilt dozer(PX): 461 ± 69N•m (47 ± 7kgf•m, 340 ± 51lbft) Semi-U dozer (EX) (cutting edge): 461 ± 69N•m (47 ± 7kgf•m, 340 ± 51lbft) Semi-U dozer (EX) (end bit): 745 ± 108N•m (76 ± 11kgf•m, 549.7 ± 79.6lbft) If bolt(2) and nut(1) are damaged, replace them with new ones at the same time. 6. After several hours of running, retighten the nuts. CLEAN, CHECK REDIATOR FINS If the radiator fins are clogged or dirty, clean and inspect them. 1. Remove bolts(1) (4 bolts), then remove cover(2). 2. Clean the radiator fins clogged with mud, dust and leaves with compressed air.

Steam or water may be used instead of compressed air. REMARK Check the rubber hose. If the hose is found to have cracks to be hardened by ageing, replace such hose with new one. Fur- ther, loosen hose clamp should also be checked. 3. Install cover(2), and tighten bolts(1). 4-29