Komatsu — REVERSE AND REPLACE THE END BITS AND CUTTING EDGES

SERVICE PROCEDURE MAINTENANCE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES It is dangerous if the work equipment moves by mistake when the cutting edges and end bits are being reversed or replaced. Set the work equipment in a stable condition, then stop the engine and lock the blade control lever securely with the safety lock lever. Reverse or replace the end bits and cutting edges before it is worn out to the blade end. 1. Raise the blade to a proper height and apply a block to the frame so as to prevent fall of the blade. 2. Operate the safety lock lever to the LOCK position. 3. Measure the wear of the end bit and cutting edge in accordance with the wear standards given below.

Wear standards Unit: mm (in) The symbols in the work equipment column have the following meaning. A: Power angle, powertilt dozer (D61EX) B: Power angle, powertilt dozer (D61PX) C: Powertilt dozer (D61PX) D: Semi-U blade (D61EX) 4-28 WARNING Item Judgement standard No. Measurement point Work equipment Standard dimension Repair limit 1 Height of out- side of end bit A 237 204 B 237 204 C 237 204 D 315 254 2 Width of end bit A 325 300 B 325 300 C 325 300 D 540 515 3 Height of inside of end bit A 204 187 B 204 187 C 204 187 D 254 237 4 Height of cutting edge (from cen- ter of bolt mount- ing hole to end face) A 102 85 B 102 85 C 102 85 D 102 85