Komatsu — CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT AND CLEAN SUCTION STRAINER

MAINTENANCE SERVICE PROCEDURE EVERY 2000 HOURS SERVICE Maintenance for every 50, 250, 500 and 1000 hours service should be carried out at the same time. CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMET AND CLEAN SUCTION STRAINER G The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the hydraulic tank strainer. G When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure,then remove it carefully. G Container to catch drained oil: Min. 44 liters capacity G Refill capacity: 44 liters (11.62US gal) 1.

Lower the blade on the ground securely, stop the engine and slowly turn the cap of oil filler(F) to release the inter- nal pressure. Then, remove the cap. 2. Remove the cover(1) at the bottom of the hydraulic tank. 3. Place a container to receive drained oil on the track under the drain hole. 4. Loosen drain valve(2) at lower side of hydraulic tank to drain the oil, then tighten valve(2) again. When loosening drain valve(2), be careful not to get the oil on you. 5. Remove grommet(3) on the underside of the fender and place a container to receive drained oil on the track under the drain hole. 6. Open cover at the right side of the machine. 7.

Using the filter wrench, turn filter cartridge(4) counter- clockwise to remove it. 4-57 WARNING