Komatsu — CHECK ALTERNATOR, STARTING MOTOR

SERVICE PROCEDURE MAINTENANCE 8. Remove bolts(4) (4 pieces) and lift up the flange of pipe(5). REMARK Lift up the flange to take out the strainer. Turn the flange by uti- lizing the slack of the rubber hose connected to the pipe. 9. Remove screws(6) (2 pieces) and pull out strainer(7). 10. Remove dirt from strainer(7), then wash the strainer in clean fuel oil or cleaning oil. 11. Install strainer(7) and secure it with screws(6), then install pipe(5) with bolts(4). 12. Install grommet(3). 13. Clean the filter holder and fill the new filter cartridge with clean engine oil.

Apply clean engine oil (or apply grease thinly) to the packings and threads of the new filter car- tridge, then install it. 14. After the packing surface of the cartridge touches the sealing surface of the filter holder, tighten the cartridge further by about 2/3 turns. Use Komatsu genuine cartridge. 15. Refill the specified quantity of engine oil through oil filler(F). 16. Check that the oil is at the specified level. For details, see "CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL (PAGE 4-44)". 17. Close the cover at right side of machine. CLEAN, CHECK TURBOCHARGER Contact your Komatsu distributor for cleaning or inspection.

CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of the rubber. If any cracks or peeling are found, contact your Komatsu distributor to have the parts replaced. CHECK ALTERNATOR, STARTING MOTOR The brush may be worn or the bearing may have run out of grease, so contact your Komatsu distributor for inspec- tion or repair. If the engine is started frequently, have this inspection carried out every 1000 hours. 4-58