MAN — Setting the valve clearance

Setting the valve clearance Fig. 4 Push feeler gauge between valve connection and rocker arm. Loosen the locknut and turn the ad- justment screw until the feeler gauge can be mo- ved with slight resistance Valve clearance: Intake: 0.5 mm Exhaust: 0.6 mm Tighten the lock nut to specified torque using the screwdriver to prevent the adjusting screw from turning. Tightening torque 22 Nm . . . . . . . . . . . . . . . . . . . . Check clearance again. 4 Refit cylinder head covers. Fig. 5 An engine cranking device (special tool) may be mounted also at the inspection hole of the flywheel housing. 5 98