Setting the valve clearance Fig. 1 Remove the cylinder head covers. Fig. 2 Use barring device to turn engine so that the piston in the cylinder to be set is at TDC and the all valves are closed. At this point both inlet and ex- haust valves will be open i.e. valves overlap. Note: As far as possible turn engine only in direction of rotation (anti−clockwise as seen when looking at the flywheel) in order to prevent the direction of rotation of the sea water pump impeller being reversed. 1 Fig. 3 Valves are in crossover in cylinder: Set valves on cylinder:
Arrangement of cylinders and valves 2 I Engine front end II Flywheel side A Exhaust valve E Inlet valve I II 3 97 1 5 3 6 2 4 6 2 4 1 5 3 1 E A 2 E A 3 E A 4 E A 5 E A 6 E A