Removing and installing cylinder head General notes The sealing effect of the cylinder head seal depends mainly on whether the required initial tension of the cylinder-head bolt is actually achieved and retained. To tighten the cylinder-head bolts, use a calibrated torque wrench. The specified final torque must be main- tained for at least 5 seconds when it is applied. When using snap-type torque wrenches, tighten the bolts gradually as otherwise the torque selected will not be fully transferred to the bolts. Observe notes on usability of cylinder head bolts, tightening sequence and specified tightening method in the publication “Engineering S Data S Setting Values”.
Tightening “Tightening” is the initial tightening of the newly fitted bolts that have not yet been tightened following a re- pair - e.g. after replacement of the cylinder head seal. Tighten the cylinder-head bolts with the engine cold, i.e. the crankcase is hand-warm or colder. Before inserting the cylinder-head bolts, apply engine oil to the thread (not the threaded hole) and coat the seating surface of the bolt head with installation paste “Optimoly White T”. Do not use oils or oil additives containing MoS 2 . In the case of unoiled bolts, a significant portion of the tightening torque is converted into friction and is thus lost for the bolt pretensioning.
D To secure the cylinder heads, tighten the cylinder head bolts only slightly D Align the cylinder heads by screwing on the straightedge (special tool). If a steel ruler is not available, use exhaust or intake manifold. D Tighten step by step in the right order and with the prescribed tightening torque and / or angle of rotation Caution: If individual bolts are tightened too much during preliminary tightening, the cylinder head is dis- torted. The distortion can no longer be removed with continued tightening in accordance with re- gulations! 96