Removing and installing valves Fig. 9 Remove the valve stem seals with a quick gripper (if available). 9 Fig. 10 Remove the washers for the valve springs. 10 Fig. 11 Turn the cylinder head over and remove the val- ves. Clean parts. Inspect the valve stem for pitting and wear. Inspect the valve guides for wear; if necessary, measure internal diameter (see “Service Data”) with a plug gauge. Inspect the valve seat inserts for burnt-out spots. 11 Fig. 12 Inspect the valve seat for heavy notching and burnt-out spots; if necessary, regrind the valves, paying attention to the valve recess (see “Service Data”) while doing so. 12 105