Replacing valve seat insert Installing valve seat insert Fig. 4 Chill the new valve seat insert down to approx. −200 ° C and insert in the cylinder head (approx. 20 ° C room temperature). Carry out a check by driving it in as far as it will go using a pressing tool. Install the valve guides. Note: When the valve seat inserts are replaced, the valve seats must also be refaced. 4 Note: D After temperature equalisation: machine the valve seats D After machining: clean the cylinder head and check for leaks with a leak testing device.
D If the cylinder head is excessively heated (above +200 ° C), the core hole covers (end covers) lose their tightness and must be replaced D To do this, clean the core holes, blow out the channels and press in new core hold covers with “LOCTITE 648” and press−in mandrel 111