MAN — Replacing valve seat insert

Replacing valve seat insert Removing valve seat insert Note: If the valve seat inserts are replaced, the valve guides must be replaced at the same time as otherwise exact refacing of the valve seat inserts cannot be guaranteed. For the above-mentioned reasons, the tool for removing and installing the valve guides and valve seat inserts have been designed in such a way that, when this tool is used, the valve guides and the valve seat inserts can be replaced only together or only the valve guides alone can be re- placed. Fig. 1 Use a valve seat machining tool (valve seat turning tool) to cut a groove approx. 3−4 mm wide in the valve seat insert.

Insert an internal puller into the cut groove and tighten. 1 Fig. 2 Note: To avoid damaging the cylinder head sealing face, lay disc Б or similar item under arms В of the support. 1 2 5 Screw threaded spindle Д into internal puller В , align arms Б of the support and pull out the valve seat insert by turning nut А . 3 4 Clean the contact face of the seat insert in the cyl- inder head. 2 Fig. 3 If a valve seat machining tool is not available, the following procedure may be adopted: D Apply two short welding beads on the valve seat (arrow) using an arc welding set D Pull out the valve seat insert D Clean the contact face of the seat insert in the cylinder head 3 110