MAN — Removing and installing camshaft

Removing and installing camshaft Removing the camshaft D Draining off coolant, see page 43 D Removing the oil pan, see page 65 D Removing the starter motor, see page 148 D Removing the flywheel and timing case, see page 117 D Removing cylinder heads, see page 91 D Remove vibration damper, see page 69 Note: The engine must be turned through 180 _ in order to remove the camshaft. To do so, the engine must be placed on assembly truck. 1 Fig. 1 Remove seawater pump with drive system. Fig. 2 Remove angle drive, cover and seawater−pump drive gear from the camshaft. 2 Fig. 3 Turn the engine upside down so that the valve tap- pets do not obstruct removal of the camshaft.

Fit insert mandrel (special tool) to camshaft. Withdraw the camshaft. Take care not to damage the camshaft bearings. Check the camshaft for wear and damage. In the case of damage to the camshaft or drive toothed gear, the entire unit (camshaft - toothed gear) must be replaced. 3 Fig. 4 Pull out the valve tappets with a magnet, check for wear and replace if necessary. Valve tappets can only be removed when the camshaft has been removed. 4 118