MAN — Removing and installing the timing case

Removing and installing the timing case D Removing the starter motor, see page 148 D Remove rpm sensor D Removing flywheel, see page 73 Fig. 1 Release the mounting bolts. The bottom of the timing case is bolted to the oil pan! 1 Fig. 2 Remove the timing case. Take the gasket off the timing case and fit a new one. 2 Fig. 3 Check the contact washer on the camshaft for wear, in necessary fitting a new one. 3 Fig. 4 Stick the new seal on with a little grease. Fit flywheel housing. In doing so, examine the oil pan gasket; replace if necessary. Lightly oil the threads and contact faces of the mounting bolts and tighten to specified torque (see “Engineering S Data S Setting values”). 4 117