MAN — Checking compression

Checking compression D Checking and/or setting valve clearance, see page 97 D Run engine up to normal operating temperature D Remove all fuel injectors, see page 32 D For compression guideline values, see publica- tion “Service Data” Fig. 1 Starting at cylinder no. 1 (cooling pump side), fit a new sealing ring and tighten down the compres- sion recorder test connection with a pressure flange. 1 Fig. 2 Insert a test chart in the compression recorder for diesel engines. Screw the compression recorder onto the test connection. Turn the engine over with the starter motor until there is no longer any needle deflection shown by the compression recorder.

In doing so, switch off the power supply of the electro-hydraulic shutoff valve (EHAB). Connect the compression recorder together with the test connection to the next cylinder and check all the cylinders as described above. 2 Fig. 3 Depending on the configuration of the compression recording device, the engine can also be turned directly from the compression recording device. Here, the electrical connections must be establis- hed at the starter motor solenoid switch (terminals 50 and 30). Compare the recorded values and remove the compression recorder and test connection. Screw in fuel injectors with nozzle and new seal, see page 35. Connect the injection and leak−off oil lines. 3 116