MAN — Removing and fitting camshaft bearing bushes

Removing and fitting camshaft bearing bushes Removing the camshaft bearing bushes Note: The engine is equipped with 7 camshaft bearings. Bearing no. 1 is located on the counter-flywheel side. Press out the camshaft bearing bush, bearing 1 Fig. 1 Use the impact extractor (special tool) to pull out the bearing bush of bearing 1 from the counter-fly- wheel side. 1 1 2 3 Fig. 2 Special tool for pressing out bearing bushes 2 to 6 from the mounting too. А Shaft with groove and fixed stop Б Double-sided guide bush В Press-out plate 2 Press out camshaft bearing bush of bearings 2, 3 and 4 Fig. 3 Use the special tool, see Fig. 2, to pull out bear- ings 2, 3 and 4 from the counter-flywheel side.

Place the guide bush Б on the shaft with groove, ensuring that you have the correct bush side (the sides have different diameters!). The spring-loaded balls lock into the oil holes. 3 2 Fig. 4 Place the press-out plate В from the other side of the stop onto the shaft and insert in bearing bush 2. 2 3 Here, insert the guide bush Б with the small diam- eter in the bearing hole and let the spring-loaded balls lock into the oil holes. The groove of the shaft must face upwards. 4 120