Removing and fitting camshaft bearing bushes Fitting the camshaft bearing bushes Fig. 11 1 2 Depending on the number of the camshaft bearing, there are various press-in plates (special too) for pressing in the bearing bushes А Shaft with groove and fixed stop Б Striking weight for А В Double-sided guide bush Г Press-out plate for bearing bushes 2 to 6 Д Press-in plate for bearing bush 1 Е Press-in plate for bearing bushes 2 to 4 Ж Press-in plate for bearing bushes 5 and 6 З Press-in plate for bearing bush 7 3 4 5 6 7 8 11 Press in the camshaft bearing bush, bearing 2 Figs. 12 and 13 Place the bearing bush on the press-in plate Е . Caution:
D One oil hole of the bearing bush must be fixed in place by the spring-loaded ball D The other oil hole must be flush with the recess of the press-in plate D The bearing bush must be seated up to the stop on the press-in plate 6 12 13 Fig. 14 Place the guide bush В on the shaft with groove, ensuring that you have the correct bush side (the sides have different diameters!). When the shaft is put in place, the groove must face upwards so that the guide bush is fixed in place by the correct oil holes. 14 3 123