Removing and fitting camshaft bearing bushes Fig. 15 Place the press-in plate Е with fitted bearing bush on the shaft. 6 The press-in plate is fixed in place by the groove so that the oil holes line up after pressing in. 15 Fig. 16 Here, insert the guide bush В with the small diam- eter in the bearing hole and let the spring-loaded balls lock into the oil holes. 3 6 The groove of the shaft must then face upwards. Apply the press-in plate Е with fitted bearing bush. 16 Fig. 17 Use a soft hammer (plastic or copper) to drive camshaft bearing bush 2 in as far as it will go. 17 Press in camshaft bearing bushes, bearings 3 and 4 1 3 4 6 Fig. 18 Arrangement of special tools:
А Shaft with groove and fixed stop В Double-sided guide bush Г Press-out plate as additional guide Е Press-in plate 18 124