MAN — Removing and fitting camshaft bearing bushes

Removing and fitting camshaft bearing bushes Fig. 19 From the counter-flywheel side, insert the press- out plate Г in bearing 2. Insert the shaft with guide bush В through bearing 1, then through the press-out plate Г (bearing 2). 3 4 6 Here, insert the guide bush В with the small diam- eter in the bearing hole and let the spring-loaded balls lock into the oil holes. The groove of the shaft must then face upwards. Place the press-in plate Е with fitted bearing bush on the shaft. The press-in plate is fixed in place by the groove so that the oil holes line up after pressing in. 19 Fig. 20 Use a soft hammer (plastic or copper) to drive the bearing bush into bearing 3 as far as it will go.

To fit bearing 4, proceed in the same manner. 20 Press in the camshaft bearing bush, bearing 1 Figs. 21 and 22 Place the bearing bush on the press-in plate. Note: The bearing bush and press-in plate Д for bearing 1 are wider than for bearings 2 to 6. 5 Caution: D One oil hole of the bearing bush must be fixed in place by the spring-loaded ball D The other oil hole must be flush with the recess of the press-in plate D The bearing bush must be seated up to the stop on the press-in plate 21 22 125