MAN — Removing and fitting camshaft bearing bushes

Removing and fitting camshaft bearing bushes Figs. 23 and 24 Arrangement of special tools: 1 5 4 6 А Shaft with groove and fixed stop Г Press-out plate for bearing bushes 2 to 6 as additional guide Д Press-in plate for bearing bush 1 Е Press-in plate for bearing bushes 2 to 4 as additional guide From the counter-flywheel side,insert the press-out plate as guide in camshaft bearing 2. Insert the press-in plate Е in bearing 3 , letting the spring-loaded ball for fixing the position of the shaft А lock into the oil hole. 23 Insert the shaft up to the stop into the press-in plate (bearing 2) and press-out plate (bearing 3). Caution: Do not twist the fixing from the groove.

The groove must face upwards. 24 Fig. 25 Place the press-in plate with fitted bearing bush on the shaft. The oil holes are covered in that the press-in plate is fixed in position by the groove of the shaft. Drive in the bearing bush with striking weight Б . 2 25 Fig. 26 Check all the pressed-in bearing bushes for seat- ing and free access to the oil holes. Caution: Check that the bearing hole matches up to the oil hole in the housing. Minimum cross section with mandrel = 2.5 mm. 26 126