MAN — Removing and fitting camshaft bearing bushes

Removing and fitting camshaft bearing bushes Fitting camshaft bearing bushes, bearings 3 and 4 1 2 Fig. 27 Special tool for pressing out bearing bushes 5, 6 and 7 from the mounting tool: А Shaft with groove and fixed stop Б Striking weight for А В Double-sided guide bush Г Press-out plate as additional guide Ж Press-in plate for bearing bushes 5 and 6 З Press-in plate for bearing bush 7 7 8 4 3 27 Fig. 28 From the counter-flywheel side, press in bearing bushes 5 and 6 as described for bearing bushes 2, 3, and 4. 3 Insert the guide bush В with large diameter in bearing 7. The groove of the shaft must then face upwards. 28 Fig.

29 Use a soft hammer (plastic or copper) to drive bearing bush 6 in as far as it will go. To fit bearing 5, proceed in the same manner. Press in the camshaft bearing bush, bearing 7 29 Fig. 30 From the flywheel side,insert the press-out plate as guide in bearing 5. Insert the press-in plate as guide in bearing 6, let- ting the spring-loaded ball for fixing the position of the shaft lock into the oil hole. Insert the shaft up to the stop into the press-in plate (bearing 6) and press-out plate (bearing 5). Caution: Do not twist the fixing from the groove. The groove must face upwards. 30 127