Removing and fitting camshaft bearing bushes Fig.31 Place the bearing bush with edge on the press-in plate. Caution: D One oil hole of the bearing bush must be fixed in place by the spring-loaded ball D The other oil hole must be flush with the recess of the press-in plate D The bearing bush must be seated up to the stop on the press-in plate 31 Fig. 32 The oil holes are covered in that the press-in plate is fixed in position by the groove of the shaft. 2 Drive in the bearing bush with striking weight Б . 32 Fig. 33 Check all the pressed-in bearing bushes for seat- ing and free access to the oil holes. Caution: Check that the bearing hole matches up to the oil hole in the housing.
Minimum cross section with mandrel = 2.5 mm. 33 128