Checking the valve timing Note: Unsynchronised valve timing can cause severe engine damage. For this reason, following engine faults that can cause twisting of the shrunk-on cam- shaft toothed wheel, the correct seating must be checked by checking the valve timing. This check is also recommended after the camshaft is fitted. Fig. 1 1 Remove the cylinder head cover from the 1st cylin- der. Set the valve clearance of the 1st cylinder cor- rectly. Turn the engine using the barring gear until the valves of the 1st cylinder overlap. Turn the engine back to approx. 50 _ before “TDC”, then turn forwards to 30 _ bevore “TDC” again. − Note the degree marking on the flywheel − Fig.
2 Place the dial gauge with approx. 2 mm initial ten- sion on the valve spring retainer of the exhaust valve on cylinder no. 1 and set to “0”. 2 Turn the engine in the running direction by 180 _ The outlet valve is then fully closed −. Read the stroke of the valve on the dial gauge. The valve stroke must lie between 4.8 and 5.7 mm. 129