MAN — Removing and installing crankshaft

Removing and installing crankshaft Removing the crankshaft D Remove oil pan (see page 65) and oil pump (see page 65) D Remove timing case, see page 117 D Remove the front cover for sealing the crank- shaft and the cylinder heads Fig. 1 Remove the bolts from the conrod bearing caps, take out the conrods with pistons and set them down in order of installation. 1 Fig. 2 Release the mounting bolts from the crankshaft bearing caps in stages from the inside outwards and remove. Remove the bearing caps and place to one side in the order of installation. Remove the bearing shell halves from the bearing caps and place to one side assigned to the bearing caps. 2 Fig.

3 Remove the lower half of the contact washers. Fig. 4 3 Lift the crankshaft out of the crankcase with hemp rope or a leather belt. Caution: If a steel cable is used, the contact sur- faces of the crankshaft bearing journals could be destroyed. Remove the bearing shells and the upper halves of the contact washers from the crankcase. If they have not yet been marked, mark the bearing shell halves for the bearing caps. Clean the parts and check for wear; replace if necessary. 4 130