MAN — Removing and installing crankshaft

Removing and installing crankshaft Check the spread of the bearing bushes Fig. 5 Place the bearing shells together on a level sur- face. Measure and note down dimensions and . Spread dimension = A−B B Install the crankshaft Fig. 6 Clean the oilways in the crankcase and in the crankshaft with dry compressed air. Thoroughly clean the bearing shells and journals. A 5 Insert the bearing bushes in the crankcase, ob- serving the numbering. Tack the upper halves of the contact washer to the crankcase with a little grease. Caution: If new bearing shells are used, pay atten- tion to the corresponding repair stage. Fig. 7 Oil the contact surfaces of the bearing shells and insert the crankshaft.

6 In doing so, note the markings of the crankshaft and camshaft gears. Fig. 8 Assemble the bearing caps with the associated bearing shells in accordance with the installations sequence. Oil the contact surfaces of the bearing shells and fit the bearing caps. Insert the bearing cap bolts and tighten to speci- fied torque in stages from the inside outwards. Tightening torque Initial torque 300 −330 Nm . . . . . . . . . . . . . . . . . . Angle tightening 90−100 ° . . . . . . . . . . . . . . . . . . . 7 Final tightening according to rotation angle method. Check that the crankshaft runs smoothly. Caution: Damaged bearing caps cannot be replaced on an individual basis. 8 131