MAN — Removing and installing crankshaft

Removing and installing crankshaft Checking axial clearance Fig. 9 Note: The crankshaft axial clearance is deter- mined by the centre crankshaft bearing (thrust bearing). D Fit the dial gauge holder with dial gauge to the crankcase D Apply the tip of the dial gauge to the crankshaft D Move the crankshaft back and forth in axial direction and read off the clearance from the dial gauge D If the permitted axial clearance is exceeded, replace the main bearing shells completely 9 Fig. 10 Measure the conrod bearings, insert the pistons with conrods. Coat the conrod bearing shells with oil and pull the conrods to the journals.

Fit the conrod bearing caps with bearing shells (observe marking - numbers must be on the same side). Screw in the mounting bolts and tighten them in stages to specified torque. 10 Final tightening according to rotation angle method. (For tightening torques and reusability of bolts, see “Service Data”). Tightening torque Initial torque 100 −110 Nm . . . . . . . . . . . . . . . . . . Angle tightening 90−100 ° . . . . . . . . . . . . . . . . . . . Fit oil pan and other detachable components. 132