Removing and installing pistons with conrods Removing pistons with conrods D Remove oil pan and oil suction pipe, see Page 65 D Removing cylinder heads, see page 91 Fig. 1 Loosen and remove conrod bearing cover bolts. 1 Fig. 2 Take off connecting rod bearingcaps with bearing shells; expediting the procedure by means of light strokes with a synthetic hammer if necessary. Note: The conrod bearing covers are numbered at the conrod foot; arrage them in corre- sponding order. 2 Fig. 3 Remove combustion residues (oil carbon) from top cylinder edge using a piece of hard wood. Caution: Do not damage the cylinder liners! Press out the conrod with piston upwards. Caution:
Do not damage the oil injection nozzles! 3 Fig. 4 Lay pistons with connecting rods and associated caps aside; use deposit rack if available. Perform visual check of piston and piston rings. Note: For reconditioned crankcase sealing faces, repair pistons with undersizes of 0.2, 0.4 and 0.6 mm in the compression height are available (see “Service Data”). 4 133