MAN — Removing and installing pistons with conrods

Removing and installing pistons with conrods Installing pistons with conrods Note: If the pistons have to be replaced, it must be determined whether oversize pistons were fitted by measuring the pistons or re- ading off the dimension on the piston crown. If this is the case, oversize pistons are to be used. Fig. 5 Check bearing bushes for wear and damage. Measure spread as in the case of main bearing bushes. If required, fit new bearing bushes. In the case of repairs to the conrod journals, use bearing bush of the corresponding repair level. 5 Fig. 6 Insert the bearing bushes in the conrod or conrod bearing cover. Caution: The rod shell has a red or yellow mark on the side.

6 The running surface must not be damaged! Apply a thin coat of oil to the conrod bushes. Fig. 7 Apply a thin coat of oil to the cylinder walls and pistons. Adjust the piston ring joints by approx. 120 ° each. Slide on the piston ring scuff band and tension the piston rings. 7 Fig. 8 Insert the piston so that the recess on the piston skirt points to the oil spray nozzle. Guide the conrod and push the piston on until it contacts the conrod foot on the conrod journal. Caution: Do not damage the oil injection nozzles! 8 134