Removing and installing pistons with conrods Fig. 9 Place the conrod bearing cap in position. Caution: The numbers on the conrod bearing cap and the conrod big end must be on one side. 9 Fig. 10 Screw in the conrod bolts and tighten them in sta- ges to the prescribed value. Final tightening according to rotation angle me- thod. (For tightening torques and reusability of bolts, see “Service Data”). 10 Fig. 11 Turn the engine slowly. The conrods and oil injection nozzles (arrow) must not collide or scuff. Note:
As far as possible turn engine only in direction of rotation (anti-clockwise as seen when looking at the flywheel) in order to prevent the direction of rotation of the sea water pump impeller being reversed. 11 135