MAN — Removing pistons from conrod and fitting, checking - replacing conrod

Removing pistons from conrod and fitting, checking − replacing conrod Removing pistons from conrod and fit- ting Fig. 1 Remove pistons with conrods. Clamp the conrod in a vice using protective jaws. Disengage piston pin fastening. 1 Fig. 2 Push out gudgeon pin, holding piston in place. Re- move piston and place to one side. 2 Measure conrod foot bore (base hole) Fig. 3 Insert the new conrod bearing and fit the cap. Tighten bolts according to regulation. Measure the bearing bore with an inside microme- ter in measuring directions 1, 2 and 3 and in pla- nes a and b. For max. permitted values, see “Service Data”. In the case of deviations beyond the tolerance range, replace conrod.

1 8 mm 8 mm 2 B A 3 3 Fig. 4 Piston pin sockets are not available. In the case of worn sockets, fit exchange conrods. 4 136