Replacing cylinder liners Checking cylinder liner protrusion Fig. 7 Clean the basic bore and the cylinder liner. Insert the cylinder liner without O-rings into the crankcase, observing the marking (ensure that it is identical to the position prior to removal). Using the dial gauge and its holder, measure the cylinder liner protrusion at no less than 4 different points. For specified values, see “Service Data”. Note: To verify that the O-rings are correctly seated after the cylinder liners are fitted, check the liner protrusion with special tool, as follows: Position the press-on measuring plate with turned collar facing the liner, using 2 fitting sleeves to centre the plate.
Tighten 4 boltsimprovised: collar bolt 51.90020−0270, length shortened to 90 mm) n the press-on measuring plate in stages and crosswise to 40 Nm. Set the dial gauge combination to “0” over the measuring plate under preload relative to the crankcase. Measure the liner protrusion at no less than 4 different points. 7 8 Fig. 8 Fit a shim if the protrusion is below the minimum level, even at only a single point. The shim is placed under the cylinder liner collar. However, it may only be used if after installation the upper tolerance limit is not exceeded. 143