Checking and setting start of fuel delivery Setting start of delivery If the check following method a) or b) reveals that the start of delivery is not correct, proceed as fol- lows: Fig. 9 Remove timing case cover. 9 Fig. 10 Release all bolts securing the drive gear to the in- jection pump hub. Two complete engine revolu- tions are necessary for this. Fig. 11 Crank the engine to the specified angle for start of delivery. Remove the cylinder head cover from cylinder no. 6 (flywheel end). When the valves for this cylinder overlap, the piston in cylinder no. 1 is at firing TDC. To do this, remove the screw plug from the gover- nor housing (see Fig. 5).
The start−of−delivery in- dicator must be visible in the centre of the inspec- tion hole. Rotate the injection pump camshaft on the drive flange accordingly to the left or the right until the conditions mentioned in a) or b) (depending on the test method used) are satisfied. Tighten the mounting bolts between the drive gear and drive flange in sequence first to 5 Nm and then to 30 Nm. Check start of delivery again. Install timing case cover. 10 11 27