Removing and installing injection pump Removing injection pump D Close shutoff valve from tank to engine. Note: The subsequent reinstallation of the injec- tion pump is rendered considerably easier if before its removal the engine has been turned to start of delivery. See chapter “Adjusting start of delivery” on page 24. Fig. 1 1 Remove all fuel lines from injection pump. Caution: The lines contain fuel! Catch escaping fuel in a suitable container. Fig. 2 Remove fuel filter with holder. 2 Fig. 3 Loosen union nuts of the injection lines. 3 4294 Fig. 4 After removal of the injection lines we recommend fitting caps to the connections on the injection pump.
This prevents dirt from getting into the injection system. Caution: Dirt in the injection system causes: D nozzles to jam D the injection pump drive to break 4 28