Removing and installing fuel injectors Fig. 15 Apply initial torque of 10 Nm to mounting bolt on connection piece. 15 Fig. 16 Tighten the mounting nut of the pressure flange (arrowed) first to 25 Nm and then to an angle of 90 _ . Then tighten connection piece to 20 Nm and after- wards tighten it using a 90 _ torque wrench. 16 Fig. 17 Secure the injection line. Initial installation: Angle tightening: 60 _ . . . . . . . . . . . . . . . . . . . . . . . . . Subsequent installation: Angle tightening: 30 _ . . . . . . . . . . . . . . . . . . . . . . . . . Afterwards tighten the mounting nut on the com- pression flange. Angle tightening 45 _ . . . . . . . . . . . . . . . . . . . . . . . . . .
Run engine up to normal operating temperature Angle tightening: 90 _ . . . . . . . . . . . . . . . . . . . . . . . . . 17 36