Removing and installing fuel injectors Check tightness of nozzle holder base, pressure pipe and leak-oil line Caution: After the injection nozzles have been in- stalled, always check to ensure that the nozzle holder seat, pressure pipe and leak-off oil lines do not leak. Figs. 18 and 19 Proceed as follows: D Loosen injection lines on the connector fitting or on the injection pump 18 D Close fuel feed, e.g. on fuel pre-cleaner with taper plug VKA10 D Switch on the ”ignition” to open the EHAB D Connect tester with adapter (Special tool) to the fuel return D Pump approx. 2 bar pressure to fuel system The pressure must not drop for a period of 3 minu- tes.
D Tighten up the injection lines again with the specified torque 19 37